Sana Rust Remover
Rust is the combination of iron, air and moisture which can gradually destroy any metal parts. SANA RUST REMOVER is a cleaner and surface modifier for mild steel, carbon steel, cast iron, copper, brass and aluminium.
Rust is the combination of iron, air and moisture which can gradually destroy any metal parts. SANA RUST REMOVER is a cleaner and surface modifier for mild steel, carbon steel, cast iron, copper, brass and aluminium. SANA RUST REMOVER can be applied by brush or sponge, roller or spray (airless - for spraying always use plastic spray machines recommended for this purpose) on surfaces to be cleaned and allow to dry. After the solution dries, the treated surface can be wiped with dry cloth or brush and surface coating can be done without washing. Rust will not form further, as the dried cleaner stays on the surface. Metal surface gets phosphatised and this film protects the metal from further rusting. Thus, in one easy to apply step, it converts rust which is unstable ferrous oxide, to stable black iron oxide magnetite and prepares the metals for practically any surface coat.
DIRECTIONS FOR USE:
SANA RUST REMOVER can be used on newly fabricated tanks, rusted body work, underside of chassis, wheel wells, garden tools, metal railings, hand tools, metal cabinets, agricultural equipment, bridges, chains, fans and ventilation housings, guard rails, storage containers,
structural steel, tank farms, water towers, containers, deck equipment, pilings, pipe line, pumps, tanks, refinery maintenance, storage tanks, oil tankers, off-shore rigs, platforms etc... made of mild steel, carbon steel, cast iron, copper brass etc...
SANA RUST REMOVER should be applied directly to rust or surfaces that may be cleaned. It may be applied with brush, sponge, roller or spray (airless special sprayers are required) and should be applied directly without dilution to rusted or unrusted metals.
When you apply SANA RUST REMOVER to the metal surface, the metal surface gets phosphatised and forms a film or seal which helps to protect the metal from further rusting. The quantity of SANA RUST REMOVER required to clean the metal surface will depend upon the thickness of rust present. When applied on very rough surfaces, we suggest you to use a dry cloth or a synthetic abrasive pad to achieve maximum penetration or to wipe the treated surface.
SANA RUST REMOVER cleans and stops most corrosion with one application and for heavily rusted surfaces and for longer term protection, we recommend a second coating also.